-Product fed into the operating area by means of specially designed feeding device is subjected to high shearing, cutting and rubbing forces between stator and rotor.

-Due to conical arrangement and the centrifugal effect of the rotor rotating at a high speed (2800 RPM), the material is forced in to the next tooth stage.

-The tooth vibrations which subject the particles with high degree of forces.

-Intence whirling multiples the grinding and mixing effect.

-Due to the slightly deviating tapeirng of the milling surface of the stator and rotor, the angular gap becomes narrower towards the discharge section.

-The processed material continuously leave the mill through the drain pipe, if required it can be re-circulated.

 

-Standard Model : Plain

-Standard Model : Water Jacketed

-GMP Model : Plain

-GMP Model : Water Jacketed

-Model as per Motor 3HP / 5HP / 20HP
-All contact parts are made out of SS304 / SS316 / SS316 L quality material.

-Coupling provided between motor shaft and rotor for the ease in maintenance.

-Special sealing arrangement between the motor and the processing chamber to prevent liquid going in side the motor winding, resulting in the burning of the motor.

-Modified design of semi concave teeth in rotor & stator gives better performance in size reduction without damaging the product.

-3 way cock system for draining and re-circulation of liquids & discharge spout for viscous products provided as a standard.

-DOL starter with overload relay for protection against single phasing and low voltage.

-Contact parts can be easily dismantled for cleaning.

-Flame proof construction provided on demand. (On extra cost )